VAP series is a compressed air operated high vacuum gate valve that was developed based on a wealth of technology and experience in the vacuum field.
The conductance when the disk is opened is large, which maximizes the pumping performance of the vacuum pump.


  • O-ring shaft seals draw little air into valves.
  • Simpler structure makes maintenance easy.
  • Use of aluminum alloy enables more lightweight design.
  • Use of link mechanism enables more compact design.
  • Low vibrations
  • Low cost


  • Evacuation system lines on vacuum equipment


Model VAP
Nominal size A(B) 100A(4B), 150A(6B)
Valve material Aluminum alloy (internal parts: mild steel, nickel plating)
Gasket material Nitryl rubber
Permitted baking temperature (℃) <60
Operating pressure range (Pa) 105 to 10-5
Leak rate (Pa・m3/s) <7.0×10-9 (*1)
Permitted ambient temperature (℃) 5 to 40
Operation type Pneumatic operation
ompressed air operating pressure (MPa) 0.3 to 0.5
OPEN/CLOSE signal output Can be attached (option) (*2)
Back-pressure Supported as standard feature
Remarks Fluororubber parts are available (option)

1. This specification uses SI measurement units.
Conversion to non-SI units is as follows: 1Pa=7.5×10-3Torr

2. Ensure that maximum differential pressure for valve OPEN/CLOSE operations is no more than 1000 Pa.
*1:a.Seal characteristic value in static state. Leak rate doesn’t include O-ring permeation /> b.Air adhering to shaft may be drawn in during valve operation, increasing apparent leak rate.
*2:Three OPEN/CLOSE signals are available. When ordering products with contacts, specify signal type and OPEN or CLOSE.